Victron BlueSolar PWM LCD & USB 12/24V 30A
SCC010030050 - The BlueSolar Charge Controller series uses Pulse Width Modulation (PWM) charge voltage control combined with a multistage charge control algorithm.
Features of the - Victron BlueSolar PWM LCD & USB 12/24V 30A
- Three stage battery charging [bulk – absorption – float]
- Battery type: Lead-ACID and LiFePO4 (with internal BMS)
- Protected against over current.
- Protected against short circuit.
- Protected against reverse polarity connection of the solar panels and/or battery.
- Low voltage load disconnect.
- Temperature protection.
Liquid crystal display
For status monitoring and set-up
Load output Over-discharge of the battery can be prevented by connecting all loads to the load output.
The load output will disconnect the load when the battery has been discharged to a pre-set voltage.
Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual.
The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
PRODUCT CODE: SCC010030050
You Might Also Like...
Home
